per page
7 Item(s)
STAINLESS STEEL SPLIT PIN 1/8"X 1" (10PACK)

STAINLESS STEEL SPLIT PIN 1/8"X 1" (10PACK)

€3.95
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 1/8"X 2" ( 5 PACK)

STAINLESS STEEL SPLIT PIN 1/8"X 2" ( 5 PACK)

€3.99
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 5/32"X1" (5PACK)

STAINLESS STEEL SPLIT PIN 5/32"X1" (5PACK)

€3.20
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 5/32"X1.5" (5 PACK)

STAINLESS STEEL SPLIT PIN 5/32"X1.5" (5 PACK)

€3.20
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 5/32"X2" (5 PACK)

STAINLESS STEEL SPLIT PIN 5/32"X2" (5 PACK)

€4.50
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 3/16"

STAINLESS STEEL SPLIT PIN 3/16"

From: €2.40

Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
STAINLESS STEEL SPLIT PIN 1/8"X 1.5" (10PACK)

STAINLESS STEEL SPLIT PIN 1/8"X 1.5" (10PACK)

€4.95
Split pins are measured along the shortest length of the pin. The nominal diameter of the pin is the size of hole it is designed to pass through. This means the pin will be fractionally smaller than its nominal diameter.
per page
7 Item(s)